Search found 4 matches

by ayush
Sat Aug 18, 2012 8:35 am
Forum: IMU
Topic: angle determination using ADXL345
Replies: 1
Views: 3571

angle determination using ADXL345

Hi, i am working on a project were i need to find the angle or tilt using the ADXL345 sensor.but i am facing problems in the calculation of it like how to calculate the angle when i am using different g's value. moreover, it's datasheet said that the output can be set to 10bit or 13bit but still i a...
by ayush
Sat Jun 02, 2012 2:03 pm
Forum: Arduino
Topic: program getting struck on arduino mini pro 3.3V, 8Mhz
Replies: 5
Views: 4665

Re: program getting struck on arduino mini pro 3.3V, 8Mhz

ya. I tried omitting that but still the problem continues. But when i am testing the individual codes it is working perfectly correct without anything hanging. but now my board is not getting burned anymore but the last code is still functioning. I need to get a new board and start testing again.
by ayush
Sat Jun 02, 2012 12:47 pm
Forum: Arduino
Topic: program getting struck on arduino mini pro 3.3V, 8Mhz
Replies: 5
Views: 4665

Re: program getting struck on arduino mini pro 3.3V, 8Mhz

this is the code i am using. its not that much clean: #include <SD.h> #include <Wire.h> #include <SoftwareSerial.h> SoftwareSerial mySerial(2, 3); #define PMTK_SET_NMEA_UPDATE_1HZ "$PMTK220,1000*1F" #define PMTK_SET_NMEA_UPDATE_5HZ "$PMTK220,200*2C" #define PMTK_SET_NMEA_UPDATE_1...
by ayush
Sat Jun 02, 2012 8:27 am
Forum: Arduino
Topic: program getting struck on arduino mini pro 3.3V, 8Mhz
Replies: 5
Views: 4665

program getting struck on arduino mini pro 3.3V, 8Mhz

Hi,
I have integrated BMP085,GPS,SD CARD and XBEE using arduino mini pro board. But when i am serial monitoring the data output, the readings stop to come after some reading. Can u explain why it is happening?

regards,
Ayush

Go to advanced search